  |
| |
| Author |
Message |
Wes39
Squirt
Joined: 15 May 2009
Posts: 1
|
 Posted: Fri May 15, 2009 6:20 pm Post subject: |
 |
|
| I was wondering. I am currently using a beat up pair of Koho 580 K series (i think that's what it is) I've been looking into the RBK P2's. I had heard their sizing was different than most brands but i've also heard that they (koho and RBK) are under the same ownership. The ATK would say i should be using smaller pads, but i love the 34" on my kohos. I'm curious as to whether or not i whether or not the 34" RBK P2 would fit the same. Any help would be awesome! |
|
|
|
mx42
Pro
Joined: 11 Jun 2007
Posts: 724
Location: southern california
|
| Posted: Tue Jun 22, 2010 12:00 am Post subject: |
|
|
| Wes39 wrote: | | I was wondering. I am currently using a beat up pair of Koho 580 K series (i think that's what it is) I've been looking into the RBK P2's. I had heard their sizing was different than most brands but i've also heard that they (koho and RBK) are under the same ownership. The ATK would say i should be using smaller pads, but i love the 34" on my kohos. I'm curious as to whether or not i whether or not the 34" RBK P2 would fit the same. Any help would be awesome! |
They will fit the same. They are the same company. |
|
|
|
Old Man Goalie
Peewee
Joined: 09 Dec 2010
Posts: 8
|
| Posted: Thu Dec 09, 2010 7:50 pm Post subject: Equipment Sizing |
|
|
MX42,
I've been following the link for a while and I thought I'd ask a question about equipment sizing for someone of a "vertically challanged" stature like myself.
I'm 5'6" and play at the adult rec league level. My team always seems to be without a goalie and since I played a little goalie as a kid and have subbed in when we can't get one, they asked me to make the change. What I'm looking for is some advice on a rec level pad that will provide adequate protection without breaking the bank. My ATK measured as you suggested is 14.5"
Any suggestions would be appreciated. |
|
|
|
calgary canuck
Peewee
Joined: 30 Mar 2011
Posts: 8
|
| Posted: Wed Mar 30, 2011 12:48 am Post subject: Re: Equipment Sizing FAQS |
|
|
| mx42 wrote: | Guys,
One of the most commonly asked questions here is "How do I size for my equipment?" After working in a shop for most of my life, I can give you some ideas on how to size for gear. You can post in this thread giving me information you can measure up yourself for, and I will help you size up for you gear.
Leg pads:
Take a tape measure.
Sit down with your leg at a 90 degree angle with the floor.
Start the tape measure at the middle of your ankle bone.
Bring it up to the middle of your knee cap along the inside of your leg.
Give me this measurement and I will be able to fit you in any pad.
Plus sizing:
When a pad is noted as "+" sized, it means there are extra inches on the thigh rise (top of the pad above the knee) to help with 5-hole closure.
Catch Glove/Blocker:
Honestly, there are so many different fits out there it is best to try them on yourself. Make sure your fingers are near the end of the finger stall on the blocker, and you should be fine in the catcher.
If you are taking a lot of shots to the stick that hurt your blocker hand, consider ordering a custom blocker next time and ask for a double layer on the palm. This really helps with cushioning the shot.
If you are taking shots to the crease/folding point on your catch glove and getting hurt a lot (not stingers, but really hurt), consider ordering a custom catcher and ask for a "pro palm." Contrary to popular belief, pros use a regular break for their game gloves, but a pro palm or double pro palm for their practice gloves.
Chest and Arm:
Overall height factors in, along with build (thin, athletic, regular, bigger). Do you wear it outside your pants or tucked in?
Pants:
Provide your waist size (around your belly button), height, build.
Skates:
Another tough area to fit. Best to do at your local pro shop, since WIDTH is a difficult factor to measure.
Take out of the footbed when you have a pair you like at the shop. Place it on the floor, and put your foot up on top of it. This will give you an idea how it will fit on your foot. For the best fit, you want your toe to just graze the tip of the boot.
Keep in mind - you will be forward on the balls of your feet a bit when you play, so make sure to simulate your stance in any skates you are trying on.
Make sure when going to a WIDE boot that you actually need the extra width. If only a few areas are bothering you on a regular sized boot, most of the time this can be rectified by punching out the problematic area. Purchasing a wide fit on a regular foot can cause a lot of problems, such as blisters, irregular buildup on the bones of the foot, loss of energy transfer, even injury. Make sure the guy you are talking to really knows his skate sizing.
RULE OF THUMB: if you are wearing a properly fitted shoe (ie. not bigger for comfort), it is 1.5 sizes DOWN from your shoe. So if you are a size 10 shoe, buy 8.5 skates.
GRAF usually fits most feet.
Bauer is built more towards narrower feet.
RBK the same.
CCM tends to fit the 'higher volume' foot - either wider or 'taller.'
Mask:
You get what you pay for. Don't skimp here. Fit is just as important as what you pay, so if you are buying a $600 mask, make sure it fits well too.
Sticks:
Tons of kids are using improperly sized sticks because they want to buy the pro model sticks that their favorite player is using. This is wrong. I have watched many kids (like 10-12 years old) using adult-sized paddle lengths on their sticks (25-26") who drop into a butterfly and use their stick to redirect the puck - only to see it roll off the blade, up their shoulder, and into the net. Paddle height is not only important in your basic stance, but in the butterfly as well. Keep this in mind.
What you need to do is size based on height and stance. Bring your skates with you to a pro shop and try different paddle heights/lie/curves.
With younger goalies who do not yet have the strength to lift the puck, try to find a straight blade stick so they can get their fundamentals down (ie. always having the stick square to the shot).
Senior paddle heights generally range from: 25-26"
Intermediate: 23-24"
Junior: 21-22"
Youth: 20" and below.
Jock:
Whatever protects and fits well. I generally pick up the bigger goalie jock and wear a regular player's jock underneath. 2 layers to disperse the impact. |
Hi there. This is my first post! Wish i had known this place was here before. I am 6'4" (ya i know huge for a goalie) and i currently have 36" pads and they seem to have alot of room in the 5 hole when in butterfly. Drives me nuts. So i did the measurement and ankle to knee is is 20.5". So your thoughts? |
|
|
|
Butters McFly
Minors
Joined: 03 Nov 2008
Posts: 110
Location: Kyushu
|
| Posted: Wed Mar 30, 2011 8:47 am Post subject: |
|
|
What do I think... well, I'm not sure exactly what kind of answer you're looking for, but... I'm 6'4" as well, with an ATK of 19.75". 36" RBK/Koho, Itech, and I presume newer Sher-Wood pads are a bit short on me, and anything else (Vaughn, Brian's, Smith) doesn't even come close.
I own a pair of 36+2" Battrams (see avatar) that I bought used. They were a tad too short, so I put a 3/4" foam block under the boot, which raises them up to proper knee level, and also gives me a little extra 5-hole coverage. I have a pair of custom-made 37+1" Vipers that, not surprisingly, fit very well, and a pair of 37" Itech Prodigy Pros that do OK.
Calgary, if you're looking for a stock pad, I recommend one of the newer (last 5 years) Itech or Bauer 38" pads with the adjustable knee lock. You can play with it until you find a happy medium between fit and 5-hole coverage. |
|
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
